Finally found the time to commit this version as revision 31.
From CHANGELOG:
As you may already know, I had to change the init code for all dpfs. Because I have access only to a limited number of frames, most of the changes were done "blind".
So: please test the new version with your dpfs and post any findings (working / not working) for the different models here.
EDIT:
Please note that the following dpfs have no or no "real" contrast-table. So there is no "Contrast" item in "Setup" menu for these types:
acme_2, agk_violet, blue, coby_dp151_white, delightdigi_2_portrait,
dx104500, dx104838, dx21334a, dx21334b,
focal, focal_portrait, linkdelight_2, linkdelight, linkdelight_3,
pearl, pearl_portrait, pink, white.
Howerever, the default contrast value will be set on init for mostly all types. No contrast setting at all only for the following types:
acme_2, agk_violet, coby_dp151_white, dx104500, dx104838
superelchi
From CHANGELOG:
* Support for model specific contrast init. * Dpf type definition moved from config.h to ./lcd/TYPE/dpfmodel.h. * New: knowntypes_builder.py builds type info from definitions in lcd/$(TYPE)/dpfmodel.h: - fw/knowntypes.py - for use by identify.py - fw/knowntypes.html - simple html page listing all supported dpfs. * Identify.py rewrite: - Commandline options (-v = verbose, -d = developer support) replace manual dev_mode editing. - Extended developer support by putting dump-snipppets and disassembler-scripts in folder fw/identify.out. - Detection of default brightness / contrast value. - Better identification of models mit non-standard init ("fake" CRC generation). - Replaced knowdpfs.py with autogenerated knowntypes.py (see knowtypes_builder.py). * Shebang added to all python scripts in folder fw. * Hint to use hiddetach if dpf is claimed by hid added to rawusb.c * Modelname change: - pearl -> pearl_portrait - pearl_landscape -> pearl - focal -> focal_portrait - focal_landscape -> focal * New model: - acme_2 - delightdigi_black_portrait - jovisa - linkdelight_2 - linkdelight_3 - pearl_custom
As you may already know, I had to change the init code for all dpfs. Because I have access only to a limited number of frames, most of the changes were done "blind".
So: please test the new version with your dpfs and post any findings (working / not working) for the different models here.
EDIT:
Please note that the following dpfs have no or no "real" contrast-table. So there is no "Contrast" item in "Setup" menu for these types:
acme_2, agk_violet, blue, coby_dp151_white, delightdigi_2_portrait,
dx104500, dx104838, dx21334a, dx21334b,
focal, focal_portrait, linkdelight_2, linkdelight, linkdelight_3,
pearl, pearl_portrait, pink, white.
Howerever, the default contrast value will be set on init for mostly all types. No contrast setting at all only for the following types:
acme_2, agk_violet, coby_dp151_white, dx104500, dx104838
superelchi